Support for: STC-2002

Expandable Thin Film Deposition Controller

The STC-2002 uses the same high speed, high resolution measurement engine as the STC-2000A, and can be expanded to control and monitor up to eight sensors. I/O can be expanded up to 32 inputs or outputs. Display and memory can also be expanded, and four user-definable buttons are available on the front panel for use with expanded I/O.

• I want to operate line voltage with the STC output card. How can I do this?
The relays on the output card are rated to 50VDC/35VAC RMS max. Switching of higher voltages and currents can be accomplished using an external relay. Detailed information in PDF format can be found on the download page under "110VAC Output Control."

• I want to use an STC-2002 where an STC-200 was installed. How do I connect the I/O?
See the STC-2002 download page for detailed instructions in PDF format on how to properly connect the I/O. Please note that switching line voltage with an STC-2002 will require an additional relay (see the FAQ above.)