Product Information for: HVPS/SC

10kV/10kW Power Supply with integrated Emission Current regulation for E-Beam Deposition

The Sycon HVPS/SC E-Beam Deposition Power Supply is a rugged, dependable deposition supply, suitable for continuous full-power usage or continuous arcing, or any combination in between. This power supply is designed for use with all commonly-used 4kV – 10kV E-beam guns.

The HVPS/SC incorporates a filament current controller for emission current regulation.

The HVPS/SC is fully tested at the factory for ripple and regulation, and is burned-in at full power. USB, RS-232 or RS-485 communications allows the supply to be connected to computer or other components in the system, such as a PLC.

FEATURES:

• 4kV - 10.2kV output voltage, 0-999mA emission current output
• Ultra-low stored energy (less than 2J @10KW out)
• 12V 70A integrated filament supply to regulate emission
• Input power: 3 phase 208V or 400V
• Built-in power line filter for low emissions
• State of the art "Green" design: Near unity power factor and >90% efficient
• Accurate: <1% ripple and regulation
• Fast arc response: Full arc recovery in about 10ms
• Rugged: Rated for continuous duty and continuous arcing, or any ratio in between
• Short circuit/over-heating/over voltage protection
• Compact: 3U height
• Programmable settings include arc rate threshold and arc delay
• Built-in USB, RS-232 and RS-485 communications standard

SPECIFICATIONS:

HV Output Current
• 0 to 999 mA
Output Voltage
• 4kV – 10.2kV
Filament Current Range
• 0 – 70 Amps, 12V
Filament Current Regulation
• Less than 1%
Ripple and Regulation
• Less than 1%
Arc event response
• Full recovery in about 15ms
Short circuit protection
• Yes
Over-voltage protection
• Yes
Over-heating protection
• Yes
User Interface
• 240 X 64 backlit high-contrast, long-life LCD, spin knob, dedicated system keys
Input Rating
• 5-36VAC/DC isolated or grounded non-isolated, contact closure
Digital Input Functions
• Door/Safety Interlock, Remote Mode, Remote On, Vac & Water Interlocks
Filament output
• Supply cable
Analog input
• 0 – 10V emission current control input
Analog outputs (2)
• 0 – 10V indicating 0 – 1000 mA
• 0 – 10V indicating 0 –10kV
Relay Rating/Output Functions
• SPST, 30V DC or RMS, 2 Amp, Power Supply On, Power Supply Ready
Communications
• USB, RS-232/RS-485
Cooling
• Forced air, two internal fans
Size
• Front panel: Standard 3U height, full rack width (5.2” H X 19.0” W)Case: 5.2” H X 17.1” W X 17.2” D
Weight
• 50 lbs
Input Power
• 3-phase, 208V or 400V
Power Factor
• Near unity